For stand-alone use, stereo audio is fed to the two 1⁄4” Input jacks, and a 9-12 volt AC power source is connected to the Power jack. Multiple Guest Pods can be “daisy chained” together using cat5 cabling so that audio and power are distributed to all units.
Another installation option is to use cat5 cabling to distribute power (only) and feed a separate audio signal to each Guest Pod.
The Cough and Talkback buttons provide SPDT contacts with LED illumination, and can be user-wired to any pinout required via the Control RJ45 connector.
The MultiPhones Guest Pod II is optimized for use with contemporary high- efficiency headphones. Because each Guest Pod contains its own amplifier, any combination of different headphones can be used. There is no interaction between units, and no degradation of audio performance regardless of the number of Guest Pods in the system. The cat5 linking uses low-Z balanced audio distribution so that long cable runs do not degrade audio quality.
The Guest Pod II is compact for convenient mounting on a desktop or attached to the underside of a counter. An optional Mounting Plate allows the unit to be mounted into cabinetry. A 12 volt AC power supply is optional.
Typical Application
Specifications
• Audio Input, RJ45 From MultiPhones Master
• Audio Input, TRS 0 dBu nom, stereo, 10K balanced
• Frequency Response 5Hz – 20 kHz, +/- 0.25 dB
• Distortion .005% typical
• Output For 24 - 600 ohm headphones
• Cough/Talkback buttons Momentary SPDT w/ LEDs
• Power Requirement MultiPhones Master or 9-12VAC, 50ma
• Physical 5.75”w X 1.75”h X 6.0”d, 1 LB
• Mounting Plate (Opt.) 5.5”w X 1.5”h; 6.0”d behind panel
• Mounting Plate cutout 4.5”w X 1.0”h
Read moreShow less
English GB
Français