CB Electronics I-Mon - 34 I/P, 27 O/P IMMERSIVE ANALOGUE MONITOR CONTROLLER FOR 14.1, 12.1, 7.1, 5.1 AND STEREO
Based on the A-Mon the I-Mon immersive analogue monitor control unit is housed in a 1U rack mount box. Designed for any format from stereo to 12 or 14 channel immersive audio. This versatile unit is designed to provide a cost effective solution to installing immersive monitoring in studios. The I-Mon may be configured with either 12 or 14 channel Main input and Main output and with either 1 or 2 talkback and listen mic inputs.
€1,950.00 VAT Excluded
Features
• Main Output 7.1.4 plus Left and Right rear Bass Extension Outputs, One or Two Stereo Alt outputs
• Inputs: 1x 7.1.4, 1x 7.1, 2 x Stereo plus 2 or 3 stereo Cue Inputs
• Dual 7.1.4 Input option
• Main Output Width: Standard 12 Channel, 14 Channel or 16 Channel On request
• Cue inputs available on cue sends and main outputs
• Four Cue outputs - Studio L/S, Headphones, Cue1, Cue 2
• Three Control Room speaker selections
• One/Two Listen back microphone inputs
• One/Two Talkback microphone inputs
• External Meter Feed (Option)
• Stereo Down Mix Output
• 34 Inputs 27 Outputs
• Stereo AFL Input
• Slate output
• Input Sum
• GPIO
Specifications
Design Rules
- To avoid any low frequency phase errors and capacitor distortion almost all signal paths in the I-Mon are DC coupled. The only exceptions are the talk back and listen back microphone inputs.
- Bass Extension Low pass filter uses Low distortion Polyphenylene Sulphide Film Capacitors
- To avoid cross talk any unused inputs are muted at the input
- DC Coupled metering with precision rectifiers to provide approximately 60 dB of range
- The NJM2068 op amp was selected for its audio performance.
- To minimise distortion audio switching via high voltage cmos (+/-14v) with a maximum signal level of +/-8v p to p
Gain Control via CS3318 gain control chip with muting and zero crossing switching for click
free input/output selection, mutes and gain control.
Inputs
• 10 kOhm balanced or unbalanced
• Input trim: -10dB to +20dB 1dB steps
• Maximum Input Level: +24 dBu @ unity gain
Outputs
• 100 Ohm balanced or 50 Ohm unbalanced
• Balanced:+4 dBu nominal, Unbalanced:6 dB below balanced line level
• Maximum Output Level:+24 dBu
• Output Trim : -4 to +4 dB in 0.5dB steps
• Frequency Response:10 Hz to 100 kHz (± 0.05 dB)
• THD+N:< 0.004% (unity gain)
• IMD:< 0.005% (unity gain)
• Noise below +4 dBu:< -90 dB (unity gain)
• Crosstalk: < -80 dB (unity gain +20dBu Input)
• Headroom: >20 dB (above +4 dBu)
• CMRR: > 55 dB (10 Hz to 20 kHz) <-60db(10Hz to 1kHz)
Data sheet
- Condition
- New
- Type
- Monitoring Controller - Actif
- Application
- Tracking, Mixing & Mastering
- Channels
- Stereo, Surround, Atmos
- Circuit
- Solid State
- Format
- 19"
- Chassis
- 1 U
- Quantity
- 1