Signex Lacing Bar LBK01
Allows to support the often heavy weight cables in the back of the Patch bays. Several possible configurations depending on the panels and their terminations. Attached to the Patch bay by four small screws (supplied) which can therefore be removed to facilitate handling during wiring and installation.
Compatible with all Signex Patchbays except the Q Patch.
Iin stock & ready to ship.
Warning: Last items in stock!
The Signex LBK01 Lacing Bar Kit provides a means of anchoring the rear connection loom and supporting if independently from the rear connectors or solder joints.
• Lacing Bar
• Mounting bracket
• M2 x 3 screw
• M3 x 6 screw
• M3 full nut
• M3 Shakeproof washer
The lacing bar is fixed to the mounting brackets as shown using the four M3 screws, nuts and shakeproof washers. The bar can be fitted either way round in any of the five locations so that the optimum position can be achieved easily. The mounting brackets are held to the front panel via the four M2 screws which locate through four clearance holes in the front panel.
Note: The four M2 screws are to provide a means of attaching the LBK01 to the connector panel you are using which makes it more manageable during installation. However, it is supported in use by being clamped between the panel
and the cabinet by the four main panel-fixing screws.
|Type||Lacing Bar Kit|
|Application||Tracking, Mixing & Mastering|