Punchlight Remote

This product is designed primarily for direct wireless control of the W-CON RX receiver. It controls both the RED and YLW signals and does not override the automatic switching function. At the same time, the function of the long press of the button (1sec and more) “RED” is integrated. This will send a new signal to the W-CON RX and start flashing for 10s. This function aims to highlight the displayed signal.

Description
Using the PunchLight Remote is very easy. On the back, just use a sharp tool to set a 3-digit code, which must be identical to the code set on the associated receiver. It is then possible to activate the corresponding signal using the RED / YLW buttons. Note that the controller works on the OFF-ON-OFF method, ie if the button was pressed before connecting the receiver to the source, in this case, the receiver can respond only to the second press of the button - this behavior is not an error.

If the RED signal was activated automatically from your DAW, for example using PunchLight WLi, it must be deactivated in the same way and cannot be canceled by the remote control. This behavior is set to prevent the “RED” signal from being accidentally turned off when starting automatically from the DAW.

Likewise, if this signal is activated with W-CON Remote, it will still on until it is deactivated again by the same controller. On the contrary, it will not respond to automatic activation from another source.

Compatible device: W-CON RX (v3.1 and higher)
Dimensions: 77 x 41 x 14 mm (3.3″ x 1.61″ x 0.55″)